1998 Oldsmobile Silhouette Owner's Manual - Page 347
1998 Oldsmobile Silhouette Manual
Page 347 highlights
Taillamps 1. Open the liftgate. 2. Remove the two screws from the taillamp housing on the inboard side. 3. Pull off the entire taillamp housing. The locatorhetaining pins on the outboard side are part of the lamp assembly and will remain intact during removal. 7. To replace the lamp assembly, line up and insert the tabs on the backof the assembly with the slots in the fender. Engage the lower clip on the of the lamp assembly, front keeping the upper tab on the parking/turn signal lamp assembly inboard of the headlamp bracket tab. 8. To align theparkinghrn signal lampassembly with the headlamp assembly, lift up the parking/turn signal lampassembly until the upper edge is contacting the fender. 9. Fasten the park/turn signal lampassembly to the headlamp assembly with the thumb screw removed in Step 1. 4. Remove the bulbholder by pressing the four retaining tabs and pulling the holder away from the assembly.