3Ware 9550SXU-8LP User Guide - Page 62

Chapter 4. Driver Installation To update the kernel with new driver source 1 Copy .c and .h files to sys/dev/twa and makefile to sys/modules/twa 2 Go to /usr/src/sys/conf/ and edit the files file (use vi or any other editor) a Remove these lines: twa/twa.c twa/twa_cam.c twa/twa_freebsd.c twa/twa_fwing.c twa/twa_globals.c b Replace them with: twa/tw_cl_fwimg.c (omit this if using code set 9.3.0.4 or newer) twa/tw_cl_init.c twa/tw_cl_initr.c twa/tw_cl_io.c twa/tw_cl_misc.c twa/tw_osl_cam.c twa/tw_osl_freebsd.c c Save changes. 3 Go to /usr/src/sys/conf/ and edit kern.pre.mk (use vi or any other editor). Below this line: INCLUDES+= -I$S/contrib/ngatm Add this line: INCLUDES+= -I$S/dev/twa Save changes. 4 Go to usr/src/sys/i386/conf or /usr/src/sys/amd64/conf, depending on whether you have a 32-bit or 64-bit version of FreeBSD 5.4 (respectively). a Edit the GENERIC file (use vi or any other editor). b Make sure Device twa # 3ware 9000 series is not commented out. c Save changes. d Do config (GENERIC, SMP, PAE), using the flags required for your hardware, followed by cd ../compile/SMP make clean make cleandepend make depend make make install 5 Reboot your system. When the system reboots, the new kernel driver module will load automatically. 52 3ware Serial ATA RAID Controller User Guide