AIWA CX-NMT50 Operating Instructions - Page 14
Basic Recording - cd player
View all AIWA CX-NMT50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
BASIC RECORDING This section explains how to record from the tuner, CD player, or external equipment. INSERTING BLANK SPACES Insertion of 4-second blank spaces enables you to activate the Music Sensor function. (Applicable when the source is TUNER, VIDEO/AUX or MD.) 1 Press the . REC/REC MUTE button during recording or while in recording pause mode. ~ on the display flashes for 4 seconds and the tape runs without recording. After 4 seconds, the deck enters the recording pause mode. 2 Press the II button to resume recording. To insert a blank space of less than 4 seconds, press the q REC/REC MUTE button again while ~ is flashing. To insert blank spaces of more than 4 seconds, after the deck enters recording pause mode, press the q REC/REC MUTE button again. Each time the button is pressed, a 4-second blank space is added. Preparation q Set the tape to the point where recording will start. q Use Type I (normal) and Type II (high/CrOz) tapes for recording. 1 Insert the tape to be recorded on into deck 2. Insert the tape with the side to be recorded on first facing out from the unit. 2 Press the REV MODE button to select the reverse mode. To record on one side only, select =. To record on both sides, select => or C=). 3 Press one of the function buttons and prepare the source to be recorded. To record from a CD, press the CD button and load the disc(s). To record from a radio broadcast, press the TUNER button and tune in to a station. To record from a connected source, press the VIDEO/AUX or MD button and play. 4 Press the q REC/REC MUTE button to start recording. When the selected function is CD, playback and recording start simultaneously. To stop recording, press the s button. To pause recording, press the 11 button. (Applicable when the source is TUNER, VI DEO/AUX or MD.) To resume recording, press again. I3 ENGLISH To erase a recording Make sure the microphone is not connected to this unit. 1 Insert the tape to be erased into deck 2 and press the TAPEI DECK 1/2 button to display 'rTP 2". 2 Set the tape to the point where the erasure is to be started. 3 Set the reverse mode by pressing the REV MODE button. 4 Press the q REC/REC MUTE button to start the erasure.