ASRock ALiveDual-eSATA2 User Manual - Page 18
Onboard Headers and Connectors
View all ASRock ALiveDual-eSATA2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
2.6 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard! Floppy Connector (33-pin FLOPPY1) (see p.10, No. 24) Pin1 FLOPPY1 the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE Connector (Blue) (39-pin IDE1, see p.10, No. 17) Secondary IDE Connector (Black) (39-pin IDE2, see p.10, No. 18) PIN1 IDE1 connect the blue end to the motherboard PIN1 IDE2 connect the black end to the IDE devices 80-conductor ATA 66/100/133 cable Note: If you use only one IDE device on this motherboard, please set the IDE device as "Master". Please refer to the instruction of your IDE device vendor for the details. Besides, to optimize compatibility and performance, please connect your hard disk drive to the primary IDE connector (IDE1, blue) and CD-ROM to the secondary IDE connector (IDE2, black). Serial ATA Connectors (Black) (SATA1: see p.10, No. 13) (SATA2: see p.10, No. 11) SATA2 SATA1 These two Serial ATA (SATA) connectors are supported by NVIDIA® nForce3 250 southbridge, support SATA data cables for internal storage devices. The current SATA interface allows up to 1.5 Gb/s data transfer rate. Serial ATAII Connectors (SATA II_1, red: see p.10 No. 9) (SATA II_2, orange: see p.10 No. 10) SATAII_2 SATAII_1 These two Serial ATAII (SATAII) connectors are supported by JMicron® JMB363 (PCIE x1 interface), support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate. 18