Acer DV433 User Manual - Page 31
Display connection using LAN, Connecting the power cord to the display, Connecting the power source
View all Acer DV433 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Connecting LAN Chapter 2 Preparation for use 31 Display connection using LAN As shown in the illustration below, you can connect this display and a computer in network through a LAN hub. Connect the display and the LAN hub using a straight type LAN cable (commercially available). How to connect • Turn off the main power switch of the computer and this display. If you make a connection while the power is on, it the devices may fail. • Connect the computer and the LAN hub using a straight type LAN cable (commercially available). • Connect this display and the LAN hub using a straight type LAN cable (commercially available). • When you connect two or more displays, you can connect the display and the LAN hub using a straight type LAN cable (commercially available) as described above. NOTE • When you use a cross type LAN cable (commercially available), you can connect the display and the computer one-to-one without using a LAN hub, however, the computer may not be supported. It is recommended to check the operation in advance. • If "LAN" control is selected, set "Standby Mode" to "Normal"; the power-on function with LAN control will not work when Standby Mode is ECO. Connecting the power cord to the display Connecting the power source Before making connections 1 Check that the main power switch is off. NOTE Please refer to "Important Safety Instructions" and "Installation, Ergonomics, Care, and Service" in this manual for proper selection of the AC power cord. Use the clamper to prevent accidental disconnection of the power cord. 2 Insert the power plug into the power outlet socket. • Fully insert the prongs into the power outlet socket. Loose connections may cause noise. • Don't plug and unplug the power cord repeatedly in a short period of time.