Acer DV433 User Manual - Page 35

Turn on the LCD Display.

Get Acer DV433 PDF manuals and user guides View all Acer DV433 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

Chapter 3 How to use the LCD Display Monitor 35 4 Turn on the LCD Display. Press the POWER button on the left side of the LCD display, or the POWER button on the top left of the infrared remote control. NOTE Within two seconds of turning off the power using the POWER button on the infrared remote control or the display or by a communication command, don't turn off the main power switch, don't disconnect the power cord, and don't turn off the breaker. If the AC power is turned off immediately after the power-off operation, all the OSD settings including the language selection may be reset to the factory defaults at the next power-on. If the OSD settings are reset to the factory defaults as described above, reconfigure the OSD settings using the following procedure. • Turn off the power of the display using the infrared remote control or another method. • Wait for at least 2 seconds. • Turn on the power of the display using the infrared remote control or another method. • Check and reconfigure the OSD settings.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
35
Chapter 3
How to use the LCD Display Monitor
4
Turn on the LCD Display.
Press the POWER button on the left side of the LCD display, or the POWER button on the top left of the infrared
remote control.
Within two seconds of turning off the power using the POWER button on the infrared remote
control or the display or by a communication command, don’t turn off the main power switch,
don’t disconnect the power cord, and don’t turn off the breaker. If the AC power is turned off
immediately after the power-off operation, all the OSD settings including the language selec-
tion may be reset to the factory defaults at the next power-on. If the OSD settings are reset to
the factory defaults as described above, reconfigure the OSD settings using the following
procedure.
•
Turn off the power of the display using the infrared remote control or another method.
•
Wait for at least 2 seconds.
•
Turn on the power of the display using the infrared remote control or another method.
•
Check and reconfigure the OSD settings.
NOTE