Adaptec 5325301507 Administration Guide - Page 180

Off-the-Shelf Backup Solutions for the SnapServer 11 To verify the success of the installation, use your backup management software to configure and run a test backup. Backup and Restore Operations with the EMC Legato NetWorker Client This section describes special procedures EMC Legato NetWorker users must use in order to perform backup and restore operations on the SnapServer. Add the SnapServer as a Root User For backup operations, NetWorker requires that the SnapServer be configured as a root user. To add the SnapServer root user as one of the administrators, use the following procedure: 1 Open the NetWorker Administrator application. 2 Click the Configuration tab. 3 Click the User Groups menu item. 4 Click on the Administrators group. 5 In the Configuration box, add one of the following: user=root@hostname where hostname is the host name of the SnapServer for each SnapServer. Or, enter: user=root to add root for all SnapServers. 6 Click OK. Recover and Retrieve Operations The EMC Legato NetWorker administrative interface does not support data recovery operations from a remote client for a Linux-based operating system such as the GuardianOS. To recover data, you must execute one of the following CLI commands from a SSH client. • Recover - The recover command restores data from a normal backup job. • Nsrretrieve - The retrieve command restores data from an archive. 164 SnapServer Administrator Guide