Adaptec 5325301507 Administration Guide - Page 89

Disks and Units Replacing a Disk Drive on a SnapServer 510, 520, 550, 620, 650, or Snap Expansion S50 When the status LED is amber and the activity LED is off, the drive has failed or is not working properly. 1 Remove the front bezel (if applicable) by pressing in the latches on each side of the bezel and pulling the bezel away from the chassis. 2 On the closed handle of the failed disk drive, press the button in and to the left to release the latch. 3 Open the handle and pull to remove the drive from the chassis. 4 Release the latch on the new drive and open its handle. If the handle is closed, you cannot insert the disk drive completely into the bay. 5 Insert the new disk drive, making sure you push it forward until it is firmly seated and the handle begins to swing closed. Then close the handle until it clicks into place to completely seat the drive to its connection. Note Be sure to push firmly on the drive to securely seat it in the drive bay before you close the handle. You should hear a click to indicate the drive has been inserted as far as it can go. 6 Replace the front bezel. Chapter 4 Storage Configuration and Expansion 73