Adaptec 5325301638 Administration Guide - Page 128
Installing a Legato NetWorker Client
![]() |
UPC - 753253016389
View all Adaptec 5325301638 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Installing Third-Party Agent Software Installing a Legato NetWorker Client This section describes how to install the Legato NetWorker UNIX/Linux client as well as special procedures Legato NetWorker users must use in order to perform backup and restore operations on the Snap Server. To Install the Legato Networker Client 1 Connect to the Snap Server via SSH, and login as admin using your admin user password. 2 To change to superuser, enter the following command and press Enter: su 3 At the prompt, enter the admin user password, and press Enter. 4 Use the cd command to change to the directory in the share, for example: cd /shares/SHARE1/agent 5 To unpackage the client files, enter the following commands: tar xvfz nw_linux86.tar.gz cd LGTOclnt rpm -Uvh --nodeps lgtoclnt-x.x-x.i386.rpm where x.x-x is the version number. 6 To start the Legato NetWorker daemon, enter the following command at the console: /etc/rc.d/init.d/networker start The NetWorker client is now installed. 7 Close the SSH client, and then return to the Administration Tool and do the following: a To disable SSH on the Snap Server, navigate to the System > SSH screen, select No, and then click OK. SSH is immediately disabled. b To start the newly installed backup agent, navigate to the Maintenance > Shutdown/Reboot screen, and click Reboot. 8 Delete the client files you copied to the Snap Server because they are no longer needed. 9 To verify the success of the installation, use your backup management software to configure and run a test backup. 114 Snap Server Administrator Guide
![](/manual_guide/products/adaptec-5325301638-administration-guide-98fc25b/128.png)