Alpine CDE-121 Owner's Manual (english, Espanol, French) - Page 9

Setting Time 1 Press SETUP to activate the SETUP mode. 2 Turn the Rotary encoder to select the CLOCK ADJ mode, and then press the Rotary encoder or / /ENT. The time indication will blink. 3 Turn the Rotary encoder to adjust the hours while the time indication is blinking. 4 When the hour has been adjusted, press the Rotary encoder or / /ENT. 5 Turn the Rotary encoder to adjust the minutes while the time indication is blinking. 6 Press SETUP to return to normal mode. • To synchronize the clock to another clock/watch or radio time announcement, press and hold the Rotary encoder or / /ENT for at least 2 seconds after setting the "hour". Minutes will reset to "00". If the display shows over "30" minutes when you do this, the time will advance one hour. • Pressing /MUTE will return to the previous mode. • If no operation is performed for 60 seconds, the unit will return to normal mode automatically. Controllable with Remote Control This unit can be controlled with an optional Alpine remote control. For details, consult your Alpine dealer. Point the optional remote control transmitter at the remote-control sensor. Remote control sensor Radio Rotary encoder SOURCE/ BAND   TUNE/A.ME /MUTE /ESC Preset buttons (1 through 6) Listening to Radio 1 Press SOURCE/ to select TUNER mode. 2 Press BAND repeatedly until the desired radio band is displayed. F1 (FM1) F2 (FM2) AM F1 (FM1) 3 Press TUNE/A.ME to select the tuning mode. SEEK DX (Distance mode) SEEK LO (Local mode) MANUAL (Manual mode) SEEK DX • The initial mode is Distance mode. Distance mode: Both strong and weak stations will be automatically tuned in (Automatic Seek Tuning). Local mode: Only strong stations will be automatically tuned in (Automatic Seek Tuning). Manual mode: The frequency is manually tuned in steps (Manual tuning). 4 Press or to tune in the desired station. Holding down or will change the frequency continuously. 8-EN