Alpine HCE-C200R Owners Manual - Page 10
Installing to a Rear Window, Securing the Camera Cable
View all Alpine HCE-C200R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Installing to a Rear Window Securing the Camera Cable 1 Secure the camera cable. Attach the waterproof pad 7 with the waterproof pad adhesive sheet 8, and secure any slack cable around the waterproof pad 7 using the cord clamp 9. 1 1 Assemble the camera mounting 3. Use the hexagonal wrench 5 to remove the camera mounting 3 and angle adjustment screw. Remove the mounting brackets, invert them, and then secure by tightening the angle adjustment screw. 3 Angle adjustment screw 2 Attach the camera to the camera mounting 3. Pull the camera cable through to the camera mounting 3, and secure with the hex screws 4. 3 1 9 7 Reverse In Camera cable • Ensure the cable does not get caught in the trunk, rear door(s) or any hinges. • The cable should go on the outside of car hinges and harness covers. • After completing wiring, open and close the trunk and the rear doors several times to confirm the cable is not getting caught or rubbing anywhere. 3 Loosen the camera mounting 3 and angle adjustment screw. Determine the attachment angle, and carefully tighten the angle adjustment screw. 4 Remove any dirt, dust, oil or chemicals from the rear window using a commerciallyavailable cleaning cloth. 5 Remove the adhesive seal from the camera mounting 3, and attach the camera mounting. • Attach the camera in a position where it does not obstruct rear visibility, or touch wipers. • Install the camera facing up so that the serial label on the rear of the camera is visible. 9-EN