Alpine HCE-C200R Owners Manual - Page 8
Installation and, Connections - front rear camera f
View all Alpine HCE-C200R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Installation and Connections Mounting the Rear Camera (HCE-C200R) Preparation 1 Check accessory parts. 1 Rear camera (1m) 2 Power unit (ACC:2m, GND:2m, Reverse In:6m, Reverse out:2m) % Cord clamp (Switch) x 3 Installing the Power Unit 1 Attach the Velcro fastener (hard side) ! to the bottom of the power unit 2. Velcro fastener (hard side) 3 Camera mounting 4 Hex screw 5 Hexagonal wrench x 2 6 RCA extension cable (2m) 7 Waterproofing pad 8 Waterproofing pad adhesive sheet 9 Cord clamp ! Velcro fastener x 5 " Tapping screw x 2 # Switch (3m) 2 Attach the Velcro fastener (soft side) ! to the floor, and secure the power unit 2. • When attaching the Velcro fastener (hard side) ! to the floor carpet, do so without the Velcro fastener (soft side) ! attached. • It is recommended to install the power unit on the rear of the instrument panel, or under a seat. Installing the Switch 1 Attach the switch # according to the following illustration. Attach the supplied switch adhesive sheet #. Peel off the seal paper, and apply it to the back of the switch, then peel off the other seal paper and install in the desired location. If necessary, secure the cable with the supplied cord clamps %. • Before attaching the switch, wipe off any dust, oil, etc., on the attaching surface with a suitable cleaning cloth (sold separately). • Attach the switch in a location where driving is not hindered. x 4 # Switch adhesive sheet $ Camera extension cable (7m) Switch 7-EN