Alpine HCE-C200R Owners Manual - Page 9
Install to the Rear Garnish, Securing the Camera Cable
View all Alpine HCE-C200R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Install to the Rear Garnish Securing the Camera Cable 1 Secure the camera cable. Attach the waterproof pad 7 with the waterproof pad adhesive sheet 8, and secure any slack cable around the waterproof pad 7 using the cord clamp 9. 1 1 Attach the camera 1 to the camera mounting 3. Pull the camera cable through to the camera mounting 3, and secure with the hex screws 4. 3 1 9 7 Reverse In Camera cable Angle adjustment screw 2 Use the hexagonal wrench 5 to loosen the camera mounting 3 and angle adjustment screw. Determine the attachment angle, and carefully tighten the angle adjustment screw. 3 Make a 13 mm hole in the rear garnish camera mounting. 2.5* 13 • Ensure the cable does not get caught in the trunk, rear door(s) or any hinges. • The cable should go on the outside of car hinges and harness covers. • After completing wiring, open and close the trunk and the rear doors several times to confirm the cable is not getting caught or rubbing anywhere. 30 21 * If the tapping screw ! is used, make a hole. 4 Pull the camera cable inside the car through the hole made in step 3. 5 Remove the adhesive seal from the camera mounting 3, and attach the camera mounting while ensuring the camera cable remains inside the grommet. • Attach the camera in a position where it does not touch the number plate. • Use retail touch-up paint to paint the surface and surrounding area when a hole has been made in a metal surface. • If necessary, use a tapping screw " to fix the camera mounting (In the case of a plastic mount area). • Install the camera facing up so that the serial label on the rear of the camera is visible. 8-EN