Alpine HCE-C200R Owners Manual - Page 11
Mounting the Front Camera HCE, C200F If HCE-C200F is purchased - + c200f
View all Alpine HCE-C200R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Mounting the Front Camera (HCEC200F) (If HCE-C200F is purchased) Preparation 1 Check accessory parts. 1 Front camera (1m) 2 Camera mounting 2 Use the hexagonal wrench 4 to loosen the camera mounting 2 and angle adjustment screw. Determine the attachment angle, and carefully tighten the angle adjustment screw. 3 Make a 13mm hole in the front bumper camera mounting. 2.5* 13 3 Hex screw x 2 5 Cord clamp x 5 7 Camera extension cable (4m) 4 Hexagonal wrench 6 Tapping screw x 4 30 21 * If the tapping screw 6 is used, make a hole. 4 Pull the camera cable inside the car through the hole made in step 3. 5 Remove the adhesive seal from the camera mounting 2, and attach the camera mounting. A B C Install to the Front Bumper 1 Attach the camera to the camera 1 mounting 2. Pull the camera cable through to the camera mounting 2, and secure with the hex screws 3. 3 1 1 A Service hole B Grommet C Make an incision in the grommet. • If necessary, use a tapping screw 6 to fix the camera mounting (In the case of a plastic mount area). 6 Connect the camera cable through the service hole to the power box. • Attach the camera in a position where it does not touch the number plate. • Use retail touch-up paint to paint the surface and surrounding area when a hole has been made in a metal surface. • Route all cables away from hot areas/parts of the car. 10-EN Angle adjustment screw