Asko W600 Service Manual - Page 24

CONTROL PANEL KNOBS (W600 AND W620) CHANGING THE KNOBS 1. Turn the knob to the 12:00 or zero position and pull it off. (If you use a polygrip (mole wrench), remember to put some soft material in the jaws so you won't scratch the plastic. Do not pry the knob off.) Knobs P/N 8061892-0 2. Install the new knob by holding it in the 12:00 or zero position and pushing it into place. CHANGING THE TEMPERATURE SELECTOR 1. Remove the top cover (see page 20). 2. Turn the knob to the 12:00 or zero position and pull it off. (If you use a polygrip (mole wrench), remember to put some soft material in the jaws so as not to scratch the plastic. Do not pry the knob off.) 3. Disconnect the terminal block. 4. Slide a thin flat-blade screwdriver through the hole in the panel to release the snap fasteners. 5. Move the selector to the left and lift it out. 6. Install a new selector and reconnect the terminal block. 7. Refit the knob and replace the top cover. Don't forget the two star washers for the outer screws. Temperature selector P/N 8061665 CHANGING THE ROTARY SELECTOR 1. Remove the top cover (see page 20). 2. Turn the knob to the 12:00 or zero position and pull it off. (If you use a polygrip (mole wrench), remember to put some soft material in the jaws so you won't scratch the plastic. Do not pry the knob off.) 3. Disconnect the terminal block. 4. Slide a thin screwdriver through the hole in the panel to release the snap fasteners. 5. Move the selector to the left and lift it out. 6. Install a new selector and reconnect the terminal block. 7. Refit the knob and replace the top cover. Don't forget the two star washers for the outer screws. Rotary selector P/N 8061728 CHANGING THE PUSHBUTTONS 1. Remove the control panel (see page 22). 2. The pushbuttons sit free on the pushbutton switches. Pull off the buttons and replace them. 3. Replace the control panel. 4. Check all the buttons to make sure there is no bind. Pushbuttons P/N 8061711-0 24