Asko W600 Service Manual - Page 55

W600 CONTROL PANEL Power Indicator Light Power Button Super Rinse Button E2 No Spin Button 800 Door Open Button Economy Button 800 RPM Spin Button Te m p e r a t u r e Control Knob Program Control Knob oF 65 85 205 105 170 160 120 140 S C 10 12 3 9 8 76 54 POWER BUTTON The Power button turns the power to the machine on and off. When the power is on, the power indicator light glows red. The power must be on before you can open the door, set the programs or start the machine. DOOR OPEN BUTTON The power must be on and you must press this button to open the door. There will be a few seconds delay before the door opens. Please note that the Program Control knob must be at the end of a program (at the 12:00 o'clock or zero position) to open the glass door. (See also, "Interrupting or Changing a Program" on page 58.) For instructions on how to open the door manually in case of power failure, refer to page 10. PROGRAMS AND OPTIONS Your ASKO washer has several programs and options specifically designed to give you the cleanest laundry possible. The table below defines each program. The C and S on the Program Control are fault codes, which are explained on page 15. Program Number Program 1 White cotton w/prewash 2 White cotton w/short prewash 3 Normal 4 Rinse 5 Long spin 6 Permanent Press/Synthetics 7 Super quick wash 8 Short spin 9 Wool/Hand wash 10 Drain Recommended Types of Laundry Temp. Range (° F) For heavily soiled cotton For normally soiled cotton For lightly soiled cottons and colorfast 140-205 140-205 105-140 For acrylic, polyester For lightly soiled fabrics For silk, nylon, washable wool 105-140 85-105 85-105 CAUTION! Some fabrics may not be able to withstand extremely hot temperatures. Please refer to the Recommended Wash Temperatures chart in the Use and Care Guide. Option Definition Super Rinse - Provides two additional rinses. Recommended for persons with sensitive skin or allergies. E2 Economy - Extends the main wash time by 22 minutes. When used with low wash temperatures (85°-100° F), this program conserves energy but gives the same high level of cleaning. Note: You can only use this option with programs 1, 2, and 3. 800 Reduces the spin speed from 1000 rpm to 800 rpm. No Spin - Omits the spin cycles in all programs. Programs 1-4 will drain the water after the last rinse. Programs 6, 7, and 9 will stop with water still in the machine. Set the Program Control knob to 10 to drain the water. 55