Asko W600 Service Manual - Page 3

Read these instructions carefully and completely before you install the machine. The installation should be carried out by a qualified person who is familiar with all local codes and ordinances for electrical and plumbing connections. NOTE: Cosmetic damage must be reported to your dealer within five days from the date of purchase. After unpacking the washer, thoroughly check the unit for cosmetic damage. SPECIFICATIONS Height 33-1/2"-34-1/2 (850-876 mm) Width 23-7/16" (595 mm) Depth W640/W660: 23-7/16" (595 mm) W600/W620: 24-7/16" (620 mm) With door open: W640/W660: 36-3/8" (923 mm) W600/W620: 42-3/8" (1075 mm) Weight 167 lbs. (73 kg) Rated load See data plate Supply voltage Single-phase 208-240 V, 60 Hz Heating element 2000 W Fuses (2) 15 A in line Drum and Barrel Stainless steel Outer casing Stove-enamelled hot-dipped galvanized steel Mounting Four adjustable rubber-covered feet Inlet supply hose 5 ft. (1.5 m) PEX tubing with brass ferrules Supply pressure 15-142 PSI Outlet hose 5.5 ft. (1.7 m) polypropylene hose, 3/4" ID Power cord supplied 220V, 20A SHIPPING SUPPORTS The machine is transported with three shipping supports, as illustrated to the right. These supports hold the tub in place during shipment. When you unpack the machine, you must remove these supports before you run the washer. WARNING Failure to remove the shipping supports before you run the washer could damage the unit. INSTALLATION REMOVING THE SHIPPING SUPPORTS Before the machine can be used, the three shipping supports must be removed. Each support consists of a bolt, a screw, a washer and a shipping sleeve. The sleeves are used after the supports have been removed, to plug the holes in the transport beam. IMPORTANT Keep the screws and washers in a safe place in case the machine has to be transported again later on. You must remove the shipping supports before you install the washer. WARNING Be careful of sharp edges. To remove the shipping supports, follow the instructions below: 1. Unscrew the 5/8" (13 mm) bolts holding the supports in place and remove the bolts. 2. Push the rubber spacer up then pull it out of the slot. 3. Rotate the spacer so that the extruded end points toward the machine. Insert it into the slot and push down to lock it into position. 4. Repeat procedures 1, 2, and 3 for the two remaining shipping supports. 3