Asko W600 Service Manual - Page 28

FRONT PANEL (W600 AND W640) REMOVING THE FRONT PANEL (W600 AND W640) 1. Remove the detergent drawer (see page 21). 2. Open the drain pump cover. (Use the partition from the detergent drawer or a flat-blade screwdriver.) 3. Being careful not to break off the drain plug, disconnect the drain hose. NOTE There may be water left in the machine that will run out through the drain hose. It's a good idea to place a towel or shallow bowl underneath the drain hose to catch the water. 4. Unscrew the emergency opening handle. 5. Remove the lower right screw from the panel, and the two screws beneath. 6. Remove the panel by moving its lower edge outwards and then pulling it down. REPLACING THE FRONT PANEL 7. Transfer the securing clips from the side panels to the front panel. 8. Press the panel into place. 9. Replace the screws at the detergent drawer and on the lower edge. Don't forget the two star washers for the screws at the lower edge. 10. Screw back the emergency door opening handle and reconnect the drain hose to the drain plug. 11. Replace the detergent drawer. Front panel W600/W640 P/N 8063925 CHANGING THE PLASTIC LOCKING CLIPS ON THE FRONT PANEL 1. Remove the front panel. 2. Squeeze the clip together and pull it out. 3. Push the new clip in until it snaps into place. 4. Replace the front panel. Plastic lockings P/N 8061763 CHANGING THE FRONT PANEL SECURING CLIPS 1. Remove the front panel. Securing clips P/N 8061658 2. Squeeze the securing clip and pull it out. 3. Insert the new clip into the hole in the front panel and push down until it snaps into place. 4. Replace the front panel. 28