Asus P5GD2 Deluxe P5GD2 Premium user''s manual - Page 49

P5GD2 PREMIUM 3 . IDE RAID connectors (40-1 pin PRI_RAID1 [blue], SEC_RAID1 [black]) These connectors are for Ultra ATA 133/100/66 signal cables. These connectors support up to four IDE hard disk drives that can be configured as a disk array through the onboard IDE RAID controller. Refer to Chapter 5 for details on how to set up RAID configurations. These connectors are set to IDE mode by default. In IDE mode, you can connect IDE devices to these connectors such as boot/data hard disk drives or optical drives. If you intend to create an IDE RAID set using these connectors, set the I T E 8 2 1 2 F C o n t r o l l e r item in the BIOS to RAID Mode. See section "4.4.6 Onboard Devices Configuration" for details. SEC_RAID1 PIN 1 ® PRI_RAID1 PIN 1 NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. P5GD2 PREMIUM RAID connectors • Before creating a RAID set using Ultra ATA hard disks, make sure that you have connected the Ultra ATA signal cable and installed Ultra ATA 133/100/66 hard disk drives. • The system automatically assigns the boot sequence of ATAPI devices connected to the IDE RAID connectors. • The ITE® 8212F controller supports a maximum of 2 Ultra ATA hard disk drives. • Set both drives either as Master or Slave before configuring a RAID 1 set. ASUS P5GD2 Premium 2-25