Asus P5GD2 Deluxe P5GD2 Premium user''s manual - Page 51

GND RSATA_TXP2 RSATA_TXN2 GND RSATA_RXP2 RSATA_RXN2 GND GND RSATA_TXP4 RSATA_TXN4 GND RSATA_RXP4 RSATA_RXN4 GND P5GD2 PREMIUM GND RSATA_TXP1 RSATA_TXN1 GND RSATA_RXP1 RSATA_RXN1 GND GND RSATA_TXP3 RSATA_TXN3 GND RSATA_RXP3 RSATA_RXN3 GND 5 . Serial ATA RAID connectors (7-pin SATA_RAID1, SATA_RAID2, SATA_RAID3, SATA_RAID4) These connectors are for Serial ATA signal cables. These connectors support up to four Serial ATA hard disk drives that can be configured as a disk array through the onboard SATA RAID controller. Refer to Chapter 5 for details on how to set up Serial ATA RAID configurations. You can configure a RAID 0, RAID 1, RAID 10, RAID 5 or JBOD sets on these connectors. SATA_RAID2 SATA_RAID4 ® SATA_RAID1 SATA_RAID3 P5GD2 PREMIUM SATA RAID connectors • These connectors are set to SATA mode by default. See section "4.4.6 Onboard Devices Configuration" for details on changing the connectors configuration to IDE mode. • When in IDE mode, you can connect Serial ATA boot/data hard disk drives to any of these connectors. • Before creating a RAID configuration, make sure that you have connected the Serial ATA cables to these connectors and have installed the Serial ATA hard disks; otherwise, you cannot enter the Silicon Image RAID utility and Serial ATA BIOS setup during POST. • You can only create RAID 5 and JBOD configuration using the SATALink™ SATA RAID Management software. See Chapter 5 for details. • The RAID 5 driver is not Windows Hardware Quality Labs (WHQL) certified. • All four Serial ATA ports are master ports. You can install Serial ATA boot disks on any of these ports. ASUS P5GD2 Premium 2-27