Asus TX97-N TX97-N User Manual - Page 17

III. INSTALLATION 2. System Memory (DIMM) Only Dual Inline Memory Modules (DIMM's) can be used with this motherboard. Two sockets are available for 3.3Volt (power level) Unbuffered Synchronous DRAMs (SDRAM) or EDO DRAM of either 8, 16, 32, 64, or 128MB to form a memory size between 8MB to 512MB. One side (with memory chips) of the DIMM module takes up one Row on the motherboard. To utilize the chipset's Error Checking and Correction (ECC) feature, you must use a DIMM module with 9 chips per side (standard 8 chips/side + 1 parity chip) and make the proper settings in the BIOS Chipset Features Setup. IMPORTANT: Memory speed setup is required through "Auto Configuration" in BIOS Chipset Features Setup. Install memory in any combination as follows: DIMM Location 168-pin DIMM Memory Modules Total Memory Socket 0 (Rows 0&1) SDRAM/EDO 8, 16, 32, 64, 128MB x1 Socket 1 (Rows 2&3) SDRAM/EDO 8, 16, 32, 64, 128MB x1 Total System Memory (Max 256MB) = ASUS DIMM Module Examples: Parity EDO DIMM (9 chips) III. INSTALLATION (System Memory) Non-Parity SDRAM DIMM (8 chips) General DIMM Notes: (not true for all memory modules) • Four possible memory chips are supported: EDO or SDRAM with and without parity. • SDRAM chips are generally thinner with higher pin density than EDO chips. • BIOS shows EDO or SDRAM memory on bootup screen. • 8 chip/side modules do not support parity, only 9 chip/side modules support parity. • Single sided modules are usually 16 or 64 MB, double sided are usually 8, 32, or 128MB. ASUS TX97-N User's Manual 17