Axis Communications M7010 M7010 Video Encoder - User Manual - Page 4
Hardware Overview
![]() |
View all Axis Communications M7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
AXIS M7010 Hardware Overview Hardware Overview 1 2 3 45 6 10 11 12 7 8 9 13 14 15 1. Video input connectors 2. LED indicators 3. Group 1 (4 video input connectors) 4. Group 2 5. Group 3 6. Group 4 7. Power connector 8. SD memory card slot (micro SD) 9. RS-485/RS-422 connector 10. Control button 11. Network connector (P0E) Connectors For technical specifications, see page 44. Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE). NOTICE Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similar shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. See for regulatory requirements. SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage. NOTICE To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System Options > Storage > SD Card and click Unmount. Control button - The control button is used for: • Connecting to an AXIS Video Hosting System service. See page 32. To connect, press and hold the button for about 1 second until the Status LED flashes green. • Connecting to AXIS Internet Dynamic DNS Service. See page 33. To connect, press and hold the button for about 3 seconds. 4
![](/manual_guide/products/axis-communications-m7010-m7010-video-encoder-user-manual-0de6ddf/4.png)