Behringer iNUKE NU3000DSP Manual - Page 10

10 iNUKE NU6000DSP/NU3000DSP/NU1000DSP User Manual Output Meters 3.3.4 Configuration The output meters show the signal level at the end of the DSP signal chain, following the Limit module. If the signal activates the limiter, the red Limit indicator will light over the channel experiencing an overload. 3.3.2 Function Tabs The BEHRINGER Amp Remote window allows the user to access DSP functions via embedded tabs accessible near the top of the software window. The Configuration tab displays two main sets of software controls: • Mode-controls the amplifier configuration. Choose between Dual Mono, Stereo, Bi-Amp 1, Bi-Amp 2, and Bridge configurations. Each configuration's complete signal path appears in the display window, including the arrangement of internal DSP modules and speaker outputs. • Delay/Peak Limiter-controls settings for the Delay and Limit DSP modules, as well as options for channel phase, Load settings (in Ohms) for the limiter wattage display, Hold and Release for the Limiter, and channel linking. The number of Delay/Peak Limiter controls change depending on the amplifier Mode configuration. Mode The software window includes these tabbed screens: • Configuration-controls the amplifier Mode setting for Dual Mono, Stereo, and other routing options, as well setting controls for output delay and limiting. • Filter/Crossover-offers control over adjustable hi-pass and lo-pass filters. In Bi-Amp 1 and Bi-Amp 2 configuration, this tab controls the crossover point for splitting the blended, mono input signal into separate high- and low-frequency mono signals for bi-amping. • Parametric EQ-controls up to 8 adjustable parametric and shelving EQs for each channel. • Dynamic EQ-adjusts parameters for 2 bands of level-dependent, dynamic equalization per channel. • Setup-manages presets and networking options. 3.3.3 Connection Status The software displays the connection status in the top header of the main software window. BEHRINGER Amp Remote [not connected!] When the amp/software connection is active, the window heading displays the name of the amplifier. BEHRINGER Amp Remote [Device: NU1000DSP!] Stereo Bi-Amp 1 Bi-Amp 2 Bridge Changing amplifier mode The amplifier mode can be changed by clicking on the button for your desired routing option along the left-hand side of the window. When you click on a mode button, the software will launch a confirmation window. Click "Yes" in the confirmation window to launch the new amplifier mode, and the new signal path will appear in the display. Mode descriptions Dual Mono Stereo Bi-Amp 1 Bi-Amp 2 Bridge Dual Mono mode routes each channel input, A and B, through completely separate parallel signal paths with independent outputs for each channel. Each channel may be processed with its own unique filter, equalization, delay, and limiter settings. The Delay and Limit modules for A and B can be linked and programmed with identical settings by clicking on the Channel Link button below the Mode window. Stereo Stereo Bi-Amp 1 Bi-Amp 2 Bridge