Beko WMI71641 User Manual - Page 10

Adjusting the feet C Do not use any tools to loosen the lock nuts. Otherwise, they can be damaged. 1. Manually (by hand) loosen the lock nuts on the feet. 2. Adjust them until the machine stands level and firm. 3. Important: Tighten all lock nuts up again. Connecting to the water supply. Important: • The water supply pressure required to run the machine must be 1-10 bar (0,1 - 1 MPa). (Practically, it is necessary to have 10 - 80 liters of water flowing from the tap in one minute to have your machine run smoothly.) Attach a pressure-reducing valve if the water pressure is higher. • Connect the special hose supplied with the machine to the water intake valves on the machine. at the tap and machine connection ends of the hoses. The plain end of the hose fitted with a filter must be attached to the tap and the elbowed end must be attached to the machine. Tighten the nuts of the hose well by hand; never use wrenches to tighten the nuts. • Open the taps completely after making the hose connection to check if there is any water leakage at the connection points. Turn off the tap and remove the nut in case of any leakage. Retighten the nut carefully after checking the seal. To prevent any water leakage and any other damage to be caused by it, keep the taps closed when the machine is not in use. • Models with a single water inlet should not be connected to the hot water tap. Laundry may be damaged or the appliance may switch to protection mode and not work. When returning the appliance to its place after maintenance or cleaning, care should be taken not to fold, squeeze or block the hoses. Connecting to the drain The water discharge hose can be attached to the edge of a washbasin or waste water system. The drain hose should be firmly fitted into the drain as to not loosen in its housing. • In order to prevent water leakage that may occur at the connection points, Important: there are rubber seals (4 seals for the • The end of the drain hose can be models with double water inlet and 2 directly connected to the wastewater seals for other models) attached to the drain or to the washbasin. The hoses. These seals should be used fitting must be secured in all types 10 EN