Beko WMI71641 User Manual - Page 25

6 Quick instructions for daily use Preparation 1. Turn the tap on completely. Check that the hose is connected tightly. 2. Place the laundry in the machine. 3. Add detergent and softener. Starting 1. Press the "On/Off" button. 2. Select the Programme and the temperature. 3. If desired (according to your machine's model): - select any auxiliary function, - adjust the spin speed, - set the time delay, 4. Close the loading door. 5. Press "Start/Pause/Cancel" button. The display shows the time remaining for the Programme to complete if time delay is not set. The display shows the time remaining for the Programme to start if the time delay is set. 6. Check if the Door Locked Symbol lights up on the screen. The Door Locked Symbol will light up if time delay is not set. The Door Locked Symbol will fade if time delay is set. Cancelling a Programme 1. Press and hold the "Start/Pause/ Cancel" button for about 3 seconds; the Start symbol will start flashing. 2. The machine can discharge all the water or can take in water for 3 times at most to cool down the clothes and complete discharging process. Adding more laundry • This is only possible under the following conditions: - during time delay, C You may add or remove laundry during the time delay (until the Programme starts). At the beginning of a washing cycle (machine allows adding more laundry during a future step only if the water level is low enough to open the loading door or if the temperature in the machine is low). In order to add laundry after the startup of the Programme: 25 1. Press "Start/Pause/Cancel" button. 2. Open the loading door and put in more laundry. 3. Close the loading door. 4. Press "Start/Pause/Cancel" button. Programme is in rinse hold mode C This process is shown with the flashing spin symbol and the standby symbol which is lit up. If you wish to spin when the machine is in this mode: 1. Adjust the spin speed. 2. Press "Start/Pause/Cancel" button. The Programme continues, pumps out the water and spins. 3. The standby symbol fades out and the start symbol lights up. If you want to discharge the water without spinning: 1. Press "Start/Pause/Cancel" button. 2. The standby symbol fades out and the start symbol lights up. 3. The Programme continues and only pumps out the water. Re-spinning the laundry The control system for an unbalanced load can pause the spinning in cases when the distribution of the laundry in the drum is not balanced. If you want to re-spin the clothes: 1. Distribute the laundry in your machine for a balanced load. 2. Select the spin Programme. 3. Adjust the spin speed. After the Programme is finished Programme indicator symbols on the screen will remain lit after the Programme is finished. "End" will appear on the screen. 1. Open the loading door and take out the laundry when the door locked symbol on the display fades out. 2. Press the "On/Off" button. 3. Turn the water tap off. 4. Remove any folds in the rubber seal on the loading door and check for debris. 5. Leave the loading door and detergent drawer open to dry. EN