Beko WMI71641 User Manual - Page 11

Electrical connection, Destroying the packaging, material, Disposing of the old machine - leaking

Page 11 highlights

of connections. Your house may be Electrical connection flooded if the hose falls out of its Connect the machine to an earthed outlet housing during water discharging. protected by a fuse of suitable capacity. • The hose should be attached to a Important: height of at least 40 cm, and 100 cm • Connection should comply with at most. national regulations. • Power cord plug must be within easy reach after installation. • The voltage and the allowed fuse protection are specified in the section "Technical Specifications". • The specified voltage must be equal to your mains voltage. • Connection via extension cords or multi-plugs should not be made. B A damaged power cable must be replaced by a qualified electrician. • In case the hose is elevated after B A faulty appliance must not be operated whilst faulty until it has been laying it on the floor level or close to repaired! There is the risk of electric the ground (less than 40 cm above the shock! ground), water discharge becomes more difficult and the laundry may come out wet. Therefore, the heights described in the figure should be followed. • To prevent dirty water refilling the machine, and to allow for easy discharge, the end of the hose must not be submerged in the drain water. The end of the hose must be able to take in air. The hose should be pushed into the drainage for more Destroying the packaging material Packaging material can be dangerous to children. Keep the packaging materials out of reach of children or dispose them by classifying according to waste directives. Do not dispose of them together with normal domestic waste. Packaging materials of your machine are manufactured from recyclable materials. than 15 cm. If it is too long you may have it shortened. Disposing of the old machine • The end of the hose should not be Dispose of your old appliance in an bent, it should not be stepped on and environmental friendly manner. it must not be folded between the • You may refer to your local agent or drain and the machine. solid waste collection center in your • The length of the hose is too short, municipality to learn how to dispose of you may add an extension hose to the your machine. original section. The length of the hose Before disposing of your old washing must not be longer than 3.2 m after machine, cut off the mains plug and make coming out of the machine. To avoid the door lock unusable. water leakage failures, the connection between the extension hose and the drain hose of the product must be fitted well with an appropriate clamp as not to come off and leak. 11 EN

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

EN
11
of connections. Your house may be
flooded if the hose falls out of its
housing during water discharging.
The hose should be attached to a
height of at least 40 cm, and 100 cm
at most.
In case the hose is elevated after
laying it on the floor level or close to
the ground (less than 40 cm above the
ground), water discharge becomes
more difficult and the laundry may
come out wet. Therefore, the heights
described in the figure should be
followed.
To prevent dirty water refilling the
machine, and to allow for easy
discharge, the end of the hose must
not be submerged in the drain water.
The end of the hose must be able
to take in air. The hose should be
pushed into the drainage for more
than 15 cm. If it is too long you may
have it shortened.
The end of the hose should not be
bent, it should not be stepped on and
it must not be folded between the
drain and the machine.
The length of the hose is too short,
you may add an extension hose to the
original section. The length of the hose
must not be longer than 3.2 m after
coming out of the machine. To avoid
water leakage failures, the connection
between the extension hose and the
drain hose of the product must be
fitted well with an appropriate clamp
as not to come off and leak.
Electrical connection
Connect the machine to an earthed outlet
protected by a fuse of suitable capacity.
Important:
Connection should comply with
national regulations.
Power cord plug must be within easy
reach after installation.
The voltage and the allowed fuse
protection are specified in the section
“Technical Specifications”.
The specified voltage must be equal
to your mains voltage.
Connection via extension cords or
multi-plugs should not be made.
B
A damaged power cable must be
replaced by a qualified electrician.
B
A faulty appliance must not be
operated whilst faulty until it has been
repaired! There is the risk of electric
shock!
Destroying the packaging
material
Packaging material can be dangerous to
children. Keep the packaging materials out
of reach of children or dispose them by
classifying according to waste directives.
Do not dispose of them together with
normal domestic waste.
Packaging materials of your machine are
manufactured from recyclable materials.
Disposing of the old machine
Dispose of your old appliance in an
environmental friendly manner.
You may refer to your local agent or
solid waste collection center in your
municipality to learn how to dispose of
your machine.
Before disposing of your old washing
machine, cut off the mains plug and make
the door lock unusable.