Beko WMI71641 User Manual - Page 24

Program in rinse hold mode, End of program - drain pump

Get Beko WMI71641 PDF manuals and user guides View all Beko WMI71641 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Program in rinse hold mode • This process is shown with the flashing Spin Symbol and the lit up Standby Symbol. If you wish to spin when the machine is in this mode: Adjust the spin speed. Press "Start/Pause/ Cancel" button. The program continues, pumps out the water and spins. The Standby Symbol fades out and Start Symbol lights up. If you want to discharge the water only without spinning: Press "Start/Pause/Cancel" button. The Standby symbol will fade. The Start symbol will light up. The program continues and only drains the water. End of program When the program is finished, the symbols of the relevant steps will remain lit up and the auxiliary function, spin and temperature data selected at the start-up of the program will remain selected. "End" will appear on the display. 24 EN

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
EN
24
Program in rinse hold mode
•
This process is shown with the
flashing Spin Symbol and the lit up
Standby Symbol.
If you wish to spin when the machine is in
this mode:
Adjust the spin speed. Press “Start/Pause/
Cancel” button. The program continues,
pumps out the water and spins. The
Standby Symbol fades out and Start
Symbol lights up.
If you want to discharge the water only
without spinning:
Press “Start/Pause/Cancel” button.
The Standby symbol will fade. The
Start symbol will light up. The program
continues and only drains the water.
End of program
When the program is finished, the symbols
of the relevant steps will remain lit up and
the auxiliary function, spin and temperature
data selected at the start-up of the
program will remain selected. “End” will
appear on the display.