Beko WMI71641 User Manual - Page 9

3 Installation Removing packaging reinforcement Tilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon. C Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the future. C Never move the appliance without the transportation safety bolts properly fixed in place! Opening the transportation locks C Transportation safety bolts must be removed before operating the washing machine! Otherwise, the machine will be damaged! 1. Loosen all the bolts with a spanner until they rotate freely ("C") 2. Remove transportation safety bolts by turning them gently. Appropriate installation location Install the appliance in environments which have no risk of freezing, in a stable and level position. C The floor must be capable of carrying the load on it! C If the washing machine and a drier are placed on top of each other, their approximate weight together may reach 180 kg when they are full. Important: • Do not place the appliance on top of the power cable. • Keep at least 1cm distance from the edges of other furniture. • Place the machine on a firm surface; do not position it on a long pile rug or such like surfaces. Raising the appliance In order to raise the appliance to eliminate the gap below the worktop, you will need to order special optional kit. Please call Beko Spare Part Department. (0845 6004911) and see built-in installation section. Gap 3. Fit the covers (supplied in the bag with the Operation Manual) into the holes on the rear panel. ("P") Without optional raising feet. With optional raising feet. Minimum height=55 mm, max height=65mm Service Ref. No. 1493 9 EN