BenQ W7000 User Manual - Page 37
Locking control keys, Turning the projector off - all lights flash
View all BenQ W7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
The On-Screen Display (OSD) menus can be set according to your preferences. The following settings do not affect the projection settings, operation, or performance. • Menu Display Time in the System Setup > Menu Settings menu sets the length of time the OSD will remain active after your last key press. Use / to select a suitable time length. • Menu Position in the System Setup > Menu Settings menu sets the OSD position in five locations. Use / to select a preferred position. • Language in the System Setup menu sets your familiar language for the On-Screen (OSD) Menus. See "Using the menus" on page 22 for details. • Splash Screen in the System Setup menu sets a preferred logo screen to be displayed during projector start-up. Locking control keys With the control keys on the remote control and projector locked, you can prevent your projector settings from being changed accidentally (by children, for example). When Key Lock is on, no control keys on the remote control and projector will operate except POWER ON/OFF and . To lock the keys: 1. Press MENU and then press / until the Advanced Setup menu is highlighted. 2. Press to highlight Key Lock, and press / to select On. A warning message appears. Select Yes and press ENTER. The control keys lock. To unlock the keys, press and hold on the projector or remote control for 3 seconds. Advanced Setup Lamp Settings HDMI Settings Baud Rate Test Pattern High Altitude Mode Password Key Lock Reset All Settings ISF S-Video 115200 Off Off Back Turning the projector off To turn the projector off, press POWER OFF on the remote control to turn the projector off directly. Or you can press II on the projector and a warning message appears. Press II again. • The Power indicator light flashes orange and the fans run for about two minutes to cool the lamp. The projector will not respond to any commands until the cooling process is complete. • Then, the Power indicator light is a steady orange once the cooling process has finished and fans stop. • If the projector will not be used for an extended period, unplug the power cable from the power outlet. • To protect the lamp, the projector will not respond to any commands during the cooling process. Actual lamp life may vary due to different environmental conditions and usage. Power Off Press off. button again to power Press any other key to cancel Connecting with video equipment 37