BenQ W7000 User Manual - Page 47
lamp out of the projector., the lamp. Use the handle to slowly pull - lamp replacement
View all BenQ W7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
1. Turn the power off and disconnect the Notes projector from the power outlet. Turn off all connected equipment and disconnect all other • cables. See "Turning the projector off" on page 37 for details. Pulling it too quickly may cause the lamp to break and scatter broken glass in the projector. To reduce the risk of injuries to fingers and damage to internal components, use caution 2. Slightly lift the projector up. Loosen the when removing lamp glass that has shattered. screws on the lamp cover (located on the left • Do not place the lamp in locations where water side). might splash on it, children can reach it, near or above heat sources, or near flammable materials. • Do not insert your hand into the projector when the lamp is removed. If you touch the optical components inside, it could cause blurred images. 6. Insert the replacement lamp. Make sure it is pushed fully and firmly in place. 7. Tighten the screws securing the lamp box. 8. Ensure the handle is fully locked in place. 3. Remove the lamp cover. 4. Loosen the screws that hold the lamp to the projector. If the screws are not loosened completely, they could injure your fingers. 5. Lift the handle so that it is perpendicular to the lamp. Use the handle to slowly pull the lamp out of the projector. Notes • Please be careful to not over-tighten the screws. • Loose screws may cause a bad connection, which could result in malfunction. 9. Re-install the lamp cover. 10. Tighten the screws on the lamp cover. 11. Reapply power and turn the projector back on. Connecting with video equipment 47