Black & Decker GH710 Type 1 Manual - GH710 - Page 9
Replacement Accessories - replacement cap
View all Black & Decker GH710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
CUTTING LINE / LINE FEEDING other hand and pull spool out. If lever (e) M Your trimmer uses .065 inch (1.65 mm) diameter, ROUND (figure N) in base of housing nylon line. During use, the tips of the nylon lines will become becomes dislodged, replace frayed and worn and the special self feeding spool will in correct position before automatically feed and trim a fresh length of line. Cutting line will inserting new spool into wear faster and require more feeding if the cutting or edging is housing. done along sidewalks or other abrasive surfaces or heavier • Remove any dirt and grass weeds are being cut. The advanced automatic line feeding from the spool and housing. mechanism senses when more cutting line is needed and feeds • Take the new spool and and trims the correct length of line whenever itʼs required. DO push it onto the boss (f) NOT BUMP unit on ground in attempt to feed line or for any other (figure N) in the housing. purposes. Rotate the spool slightly until it a is seated. • Unfasten the end of one of REPLACEMENT ACCESSORIES Use Black & Decker replacement spool Model No. DF-065. the cutting lines and guide the line into one of the eyelets (g). figure N. The line should h protrude approximately 5-3/8 inches (136mm) from the • USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON LINE. Do not use heavier gauge line as it will overload the motor and cause overheating. Do not use lighter gauge or serrated .065 inch (1.65 mm) line as it will cause overfeeding. • Other replacement parts (guards, spool caps, etc.) are available through Black & Decker service centers. To find your local service location call: 1-800-544-6986 or visit www.blackanddecker.com. WARNING: The use of any accessory not recommended by housing. • Unfasten the end of the other cutting line and guide N the line into the other eyelet. The line should protrude approximately 5-3/8 inches (136mm) from the housing. • Align the tabs on the spool cap (a) with the slots (h) in the Black & Decker for use with this tool could be hazardous. housing (figure M). • Push the cap onto the g REPLACING THE SPOOL (FIGURES M & N) • Unplug the tool. housing until it snaps securely into place. f • Depress the tabs (a) and remove the spool cap (b) from the spool housing (c) in the trimmer head (figure M). • Replace spool with Black & Decker model # DF-065. • Grasp empty spool (d) with one hand and spool housing with NOTICE: To avoid tool damage, if the cutting lines protrude beyond the trimming blade (i), cut them off so that they 9 Replacement d spool Model # DF-065 b b c i d a e b