Bosch HBL5620UC Operating, Care, Installation - Page 17

During the washing phase, the drum rotates in opposite directions at 40 rpm repeatedly. Spin speed reaches 1100 rpm for both intermediate and final spin to reduce the remaining moisture content and chemical residues contained in the loads as well as optimize the rinsing efficiency. Additional options can be selected for this program such as Rinse plus", Bleach", and Heavy duty". All these options can be selected individually or simultaneously. Selecting Rinse plus" will add an additional rinse to the program to better remove chemical residue. Selecting Bleach" option will ensure bleach dispensation at the right time. The dynamic load sensor will add enough water to dilute the bleach, preventing bleach marks on the clothes. Heavy duty" option will extend the wash phase to a longer period of time to achieve optimum wash performance (see detailed explanation of heavy duty). Rinse and Spin Program for rinsing unsoiled textiles, e.g. swimwear, and for removing detergent residue from textiles. Ends with a spin cycle. Spin Spin cycle for spinning wet, hand washed laundry. Water is drained before and during the spin cycle. Drain Can be used to drain water without a spin cycle. Temperature Settings The following wash temperatures are available: XXTRASANITARY170 °F (77 °C) Temp. boost: 150 °F (66 °C) (only Regular/Cotton) hot: 125 °F (52 °C)- warm: 95 °F (35 °C) cold: 60 °F (15 °C) Maximum spin speeds of the programs The indicator light max spin speed" is lit red. Revolutions per minute Program 1100 Regular/Cotton 800 Permanent Press 600 Delicates/Silk 800 Wool 1000 Qucik Wash 25 1100 Spin 1100 Rinse and Spin 1100 XXtra Sanitary Reduced spin The indicator light reduced spin" is lit red. Only if you have selected a reduced spin speed for gentle treatment of your laundry. Gentle spin speeds The indicator light Gentle spin speed" is lit red. Revolutions per minute Program 400 Hand Wash No final spin The indicator light no final spin" is lit red. For delicate laundry, the water remains in the machine after the last rinse. Use this setting to avoid creasing if the clothing cannot be taken out of the washing machine immediately upon completion of the cycle. CAUTION Before unloading you must drain the remaining water by selecting Drain or Spin and starting the machine. Modifiers Spin Selection Preset cycle setting of max. spin speed can be reduced. Press this button until the desired setting is indicated. Delay Start Before starting a program you can modify when the cycle should be started. Press Delay Start button. The display shows the start time 0:00. The time can be delayed up to a maximum of 19 hours (with 1 hour increments) by pressing the Delay Start button repeatedly. The Start time begins running immediately after pushing the Start/Pause button. This is indicated by the points between the digits flashing. i Changes to the Start time are possible at any time, press the Delay Start button until the new time appears. i If the program is changed or if the program is interrupted, the preselected Start time is also interrupted. The Ready in time of the program is displayed. The Start time must be reselected. 17