Bosch NWD-455V03-20P Operating Instructions - Page 21
Disassembly
View all Bosch NWD-455V03-20P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
FlexiDome IP Disassembly | en 21 2 Disassembly The camera/housing unit consists of the following parts: Mounting plate Camera module and mounting base Inner liner Trim ring and dome Fig. 2.1 Exploded view CAUTION! ! Installation should only be performed by qualified service personnel in accordance with the National Electrical Code or applicable local codes. CAUTION! ! The camera module is a sensitive device and must be handled carefully. Do not drop when disassembling the unit. To disassemble the unit proceed as follows: 1. Using the special screwdriver bit, loosen the three tamper- resistant screws in the trim ring (the screws remain in place). 2. Remove the trim ring with dome by pulling it off of the base. 3. Remove the inner liner by pulling it off of the base. 4. Loosen the three Phillips captive screws until the mounting plate separates from the body Bosch Security Systems Operating Instructions V 1.0 | 2006.12