Bosch NWD-455V03-20P Operating Instructions - Page 92
Upload, Configuration download, Download, NOTICE
View all Bosch NWD-455V03-20P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
92 en | Configuration via the browser FlexiDome IP NOTICE! A firmware update resets all camera parameters to their factory default values. If you wish to retain the old values i first save the configuration by performing a configuration download. After the firmware update you can reload your parameter values by performing a configuration upload. To update the firmware: 1. First, save the update file to the hard disk. 2. Enter the full path for the update file in the field or click Browse... to locate and select the file. 3. Click Upload to begin transmission to the unit. The progress bar allows you to monitor the transfer. NOTICE! i Installing new firmware and reconfiguring the camera takes several minutes. The new firmware is unpacked and the Flash EPROM is reprogrammed. The time remaining is shown by the message going to reset Reconnecting in ... seconds. After the upload is completed successfully, the unit restarts automatically. If the operating status LED lights up red, the upload has failed and must be repeated. To perform the upload, you must switch to a special page: 1. In the address bar of your browser, after the unit IP address enter /main.htm (for example 192.168.0.80/main.htm). 2. Repeat the upload. Configuration download You can save configuration data for the camera to a computer and load saved configuration data from a computer to the unit. 1. Click Download; a dialog box appears. 2. Follow the instructions to save the current settings. V 1.0 | 2006.12 Operating Instructions Bosch Security Systems