Bosch WTVC8330US User Manual - Page 30
TO AVOID, ELECTRICAL, SHOCK, Repairs or replacement, parts, shall be carried, out by, qualified,
UPC - 825225874430
View all Bosch WTVC8330US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Troubleshooting d WARNING TO AVOID RISK OF ELECTRICAL SHOCK! Repairs or replacement of parts shall be carried out by qualified technicians or licensed electricians only. Before calling Customer Service, check whether you can rectify the fault yourself by means of the following table. If a fault cannot be rectified or a repair is required: 1. Set program selector to Off". 2. Turn off the circuit breaker. 3. Pull the main plug out of the socket. 4. Call customer service (see page 32). Troubleshooting items listed below may not be covered by warranty service Please rule out any of these issues before calling for service. Problem Dryer does not start. Start/Pause" indicator light does not illuminate. Cycle has been interrupted. A warning signal is emitted and the display shows CLn". Cycle has been interrupted. A warning signal is emitted and the display shows E:12". Degree of drying has not been reached or the drying time is too long. Display may indicate E:03". Drum light does not function. Possible cause Main plug not inserted at all or not inserted correctly. A fuse or circuit breaker has tripped. Start/Pause" button not pressed. No program selected. Door not closed. Ambient temperature below 41°F (5 °C.) Lint filter dirty. Exhaust air duct is blocked or too long. Fault in program sequence or malfunction. The room/cabinet is not adequately ventilated. Moisture sensor dirty. Exhaust air duct is blocked or is too long. Lint filter dirty. Laundry was too wet. Unsuitable program selected. Maximum drying time was exceeded. Motor limit temperature was exceeded. Degree of dryness not correctly set No program selected. Light bulb defective, light bulb burned out. No power supply. Light bulb is loose. Remedial action Insert main plug correctly. Replace fuse or reset circuit breaker. Press Start/Pause" button. Select program. Close door. Increase room temperature. Clean the lint filter as described on page 27. Switch the dryer off/switch on again. If this does not clear the error code, call Customer Service (pg. 32). Clean exhaust air duct. Reduce exhaust air duct to maximum length as described on page 18. Switch the dryer off/switch on again. Switch off dryer, leave to cool down for 30 min, switch on again. Restart program. Provide an adequate supply of fresh air. Switch off/switch on again. Clean moisture sensor as described on page 29. Switch the dryer off/switch on again. Clean exhaust air duct. Reduce exhaust air duct to maximum length as described on page 18. Switch the dryer off/switch on again. Clean filter as described on page 27. Switch the dryer off/switch on again. Spin laundry at higher speed in the washing machine. Switch the dryer off/switch on again. Select program with aid of the program selection table (see page 22). Switch the dryer off/switch on again. Clean lint filter (see page 27). Check exhaust air duct. Spin laundry at a higher speed in your washer. Switch off dryer, leave to cool down for 30 min. Switch on again. Start program. 800 Series, Change settings for degree of dryness, see page 25 Select program. Replace burned out bulb and reinstall the cover as directed on page 29. Check power supply. Remove the bulb cover and if bulb is loose, tighten bulb. Reinstall the cover as directed on page 29. 30