Bosch WTVC8330US User Manual - Page 31

Troubleshooting (continued) Problem Start/Pause" indicator light does not illuminate. Wrinkle Block/Finished" indicator lights. The display shows 000". Lint filter LED is blinking after the lint filter has been cleaned Display shows ---". Unusual noise: thumping sound Possible cause Fault in program sequence or malfunction. Blinking of lint filter LED is not an indication of a problem. It is used only as a reminder. Laundry detected in drum during wool program (laundry not on rack) Drum suspension rollers need time to warm up. Unusual noise: Steady vibrationd, rocking of the dryer Unusual noise: Rhythmic vibration Water is not sprayed into the unit during Steam cycles Dryer is not level. Laundry balled up causing load to bounce. Water tap(s) not turned on. Nozzle does not spray water adequately. Blocked nozzle LED or button illuminated on control Fault condition panel when Cycle Selector is turned to Off" position Remedial action Switch off dryer, leave to cool down for 30 min, switch on again. Restart program. No action required. Light will stop blinking. Place laundry on dryer rack. Restart program. No action required. As suspension system rollers warm up thumping will decrease and should stop within 2 to 3 minutes of dryer use Level the dryer (see user manual section Installation Instructons" Stop dryer, separate load items, restart dryer. Turn on water tap. Wipe the outside of the nozzle with a cloth moistened with vinegar. If this does not restore the nozzle to spraying, see Blocked nozzle" remedial action below. Remove the nozzle using a 7/16 inch (11 mm) socket wrench. Place the nozzle into a container filled with enough white vinegar to cover the nozzle. Allow the nozzle to soak for five minuntes, then scrub the nozzle tip gently with a toothbrush to remove residue. Rinse the nozzle and reinsert it back into the dryer and hand tighten, then tighten 1 additional turn with the wrench. Turn off the circuit breaker and call Customer Service (pg. 32). 31