Brother International BES-961BC Instruction Manual - English - Page 154
Error, Measures, error occurs again, the Y-axis mechanism is faulty.
View all Brother International BES-961BC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
Chapter 9 List of Error Codes Code E-02 E-03 E-04 E-05 E-06 E-07 E-09 E-0A E-14 E-18 E-21 E-22 E-23 E-24 E-25 E-26 E-27 E-28 E-29 E-2A E-2B E-2C E-2D E-2E E-2F Error Overtravel error during home positioning detection Stop SW was pressed during home positioning Zero positioning is out of range Needle stop position error Needle bar case position error Needle bar case lock X-axis home position error Thread breakage error Y-axis home position error X-axis stepping motor connector error Area over Measures Turn the power off once, then on again. If the same error occurs again, the area sensor is faulty. Press and clear the error message. Pressing STOP START restarts the home position detecting movement again. Turn the power off once, then on again. If the same error occurs again, the X- or Y-axis mechanism is faulty. Adjust the pulley stop position (100°) above the needle and press . STOP Press . If the error persists, the color-change STOP mechanism is faulty. Turn the power off once, then on again. If the same error occurs again, the X-axis mechanism is faulty. After passing through the thread, press . STOP Turn the power off once, then on again. If the same error occurs again, the Y-axis mechanism is faulty. Check that the connector of the X-axis stepping motor is properly connected, and press . STOP Set the embroidering area again or move the hoop to a sewable position. (The hoop can be moved to a sewable position by pressing .) 152 BES-961BC • BES-1261BC