Brother International CS-6000/6000b/6000t Operation Manual - Page 14
For models equipped with the quick-set bobbin
View all Brother International CS-6000/6000b/6000t manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
KNOWING YOUR SEWING MACHINE Put the bobbin in so the thread comes out in the c direction shown by the arrow. CAUTION ● Make sure you set the bobbin so the thread unrolls in the right direction. If the thread unrolls in the wrong direction, it may cause the thread tension to be incorrect or break the needle. Hold the end of the thread, push the bobbin d down with your finger, and then pass the thread through the slit, as shown. ■ For models equipped with the quick-set bobbin Raise the needle to its highest position by a turning the handwheel toward you (counterclockwise) or press (needle position button) (for models equipped with the needle position button), and raise the presser foot lever. Slide the button and open the cover. b 1 2 a Cover b Slide button Put the bobbin in, feed the end of the thread, c through the slit, and then pull the thread to cut it. Replace the bobbin cover. e • Replace the cover so that the end of the thread comes out from the left side of the cover (as shown by the line in the diagram). a Cutter CAUTION ● Make sure you set the bobbin so the thread unrolls in the right direction. If the thread unrolls in the wrong direction, it may cause the thread tension to be incorrect or break the needle. • Make sure that the thread is correctly inserted through the tension-adjusting spring of the bobbin case. If it is not inserted, re-insert the thread. 1 a Tension-adjusting spring 12