Brother International Innov-is 85e Operation Manual - Page 27
machine may be damaged.
View all Brother International Innov-is 85e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Pass the end of the thread through the slit in k the bobbin winder seat, and then pull the thread to the right to cut it. a Slit in bobbin winder seat (with built-in cutter) X The thread is cut to a suitable length. When the bobbin winding becomes slow, press n (start/stop button) once to stop the machine. When the foot controller is plugged in, remove your foot from the foot controller. 1 CAUTION ● When the bobbin winding becomes slow, stop the machine, otherwise the sewing machine may be damaged. CAUTION ● Be sure to cut the thread as described. If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the bobbin may not be wound correctly. In addition, the thread may become tangled in the bobbin or the needle may bend or break when the bobbin thread starts to run out. Cut the thread, slide the bobbin winder shaft o to the left, and then remove the bobbin from the shaft. Slide the sewing speed controller to the right l (for a faster sewing speed). Memo z If the bobbin winder shaft is set to the right side, the needle will not move. (Sewing is impossible.) a Sewing speed controller Press m (start/stop button) once. When the foot controller is plugged in, press down on the foot controller. X The bobbin starts spinning and the thread is wound around the bobbin. Slide the sewing speed controller back to its p original position. Memo z When the sewing machine is started or the handwheel is turned after winding the bobbin, the machine will make a clicking sound; this is not a malfunction. a start/stop button Winding/Installing the Bobbin 25