Brother International Innov-is NQ1600E Operation Manual - Page 91
While embroidering
View all Brother International Innov-is NQ1600E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Troubleshooting Symptom Probable Cause Remedy The sewing light The sewing light is damaged. does not come on. "Light" is set to "OFF" in the settings screen. Contact your authorized dealer or the nearest Brother authorized service center. Change the setting to "ON". Embroidery unit does not operate. Embroidery unit is not attached correctly. Reattach the embroidery unit correctly. Embroidery frame was attached before the unit Remove the embroidery frame, and then was initialized. perform the initialization process correctly. Reference - B-11 B-26 B-27 ■ While embroidering Symptom Probable Cause Remedy Reference Machine does not operate. Needle breaks. Needle breaks. "Start/Stop" button was not pushed. Press the "Start/Stop" button. B-4 The bobbin winder shaft is pushed to the right. Move the bobbin winder shaft to the left. B-14 There is no pattern selected. Select a pattern. B-34 Presser foot is not lowered. Lower the presser foot. B-2 Frame-securing lever was not lowered. Lower frame-securing lever after installing embroidery frame. B-33 Needle is installed incorrectly. Reinstall the needle correctly. B-23 Needle clamp screw is not tightened. Tighten the needle clamp screw. B-23 Needle is turned or bent. Replace the needle. B-23 Using improper needle or thread for the selected fabric. Check the information about the needle and thread to be used. B-23 Upper thread tension is too tight. Adjust the thread tension. E-26 Spool cap is set incorrectly. Check the method for attaching the spool cap, B-14 then reattach the spool cap. There are scratches around the opening in the Replace the needle plate, or consult your - needle plate. authorized Brother dealer. There are scratches around the opening in the Replace the presser foot, or consult your A-5 presser foot. authorized Brother dealer. There are scratches on the bobbin case. Replace the bobbin case, or consult your A-2 authorized Brother dealer. Needle is defective. Replace the needle. B-23 A bobbin designed specifically for this machine Incorrect bobbins will not work properly. Only is not used. use a bobbin designed specifically for this machine. B-14 Upper threading is incorrect. Check the steps for threading the machine and B-19 rethread the machine. Bobbin is set incorrectly. Reset the bobbin correctly. B-17 Embroidery foot is attached incorrectly. Attach the embroidery foot correctly. A-5 Stabilizer is not attached to fabric being embroidered. Attach stabilizer. B-29 Bobbin thread is incorrectly wound. Use a correctly wound bobbin. B-14 MAINTENANCE AND TROUBLESHOOTING A Appendix A-7