Canon 1292B002 REALiS Manual - Page 118

Replacing the Lamp When the time of use of the lamp exceeds 1,400 hours (1,800 hours or longer for SX7/ X700, 2,300 hours or longer for SX60), the following message (two types) is displayed for 10 seconds each time the projector is turned on. z When the time of use is 1,400 to 1,500 hours: 1,800 to 2,000 hours for SX7/X700 2,400 to 2,500 hours for SX60 * [], the [OK] button, and the [POWER] button are available during this message is displayed. MAINTENANCE z When the time of use is 1,500 hours or longer: 2,000 hours or longer for SX7/X700 2,500 hours or longer for SX60 * The [POWER] button is available during this message is displayed. z This message will not be displayed again if you select [No] in response to the message "Do you want to display this message again?". z You can check the time of use of the lamp in [Lamp counter] in the [System settings] menu (P114). Caution z When replacing the lamp, turn off the projector, wait until the cooling fan stops, remove the power plug from the AC outlet, and let the projector stand for at least 1 hour. Otherwise, you may get burned because the main unit is very hot immediately after the projector is turned off. z Do not touch the inner glass surface when you replace the lamp. Otherwise, the projector's performance may degrade. z Make sure to handle the lamp carefully and correctly since it may explode if it is scratched or shocked. z Do not remove screws unless specified. Replacing Lamp This projector uses the following lamp. Lamp type No. SX7/X700: RS-LP04 SX6 : RS-LP02 SX60 : RS-LP03 z Be sure to use the specified lamp. z A lamp can be ordered from your dealer or Canon home page. 118