Canon 1292B002 REALiS Manual - Page 122
Troubleshooting
View all Canon 1292B002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Troubleshooting WARNING Lamp Flash Patterns The WARNING lamp on the Control Panel flashes in red when there is a trouble in the projector. z Turn off the projector, wait until the cooling fan stops, and remove the power plug from the AC outlet before dealing with the trouble. Flash Pattern One flash Meaning Temperature abnormality Two flashes Faulty lamp Three flashes Faulty lamp cover Four flashes Five flashes Faulty cooling fan Faulty power supply Six flashes System failure Countermeasure The temperature inside the projector is too high for some reason or the outside air temperature is higher than the specified one. If the problem is inside the projector, check whether the projector is installed and operated normally, turn off the projector to cool its inside, and retry projection. If the same warning occurs again, the projector may be defective. Contact your dealer. The lamp has burnt out. Replace the lamp with a new one. If the same warning is experienced again, the lamp drive circuit may be defective. Contact your dealer. The lamp cover is open. Turn off the projector and unplug it from the power outlet, then install the lamp cover and turn on the projector again. If the lamp cover has been installed properly, the lamp cover detection switch may be defective. Contact your dealer. The cooling fan or another component may be defective. Contact your dealer. The abnormal voltage is applied to some parts in the power supply or any other failure may be occurred. Turn off the projector and unplug it from the power outlet, then plug it to the outlet and turn on the projector again. Contact your dealer if the same warning is given. Some of the functions may be defective. Turn off the projector and retry projection. If the same warning is experienced again, contact your dealer. TROUBLESHOOTING 122