Canon C50FSi Network Video Recorder VK-64/VK-16 Administrator's Manual - Page 268

Messages List VK-64/VK-16 Recording Engine Logs A list of messages shown in the Storage Server log file nvr_re_log_.txt ( is either 0 or 1) is shown below. These messages are generated by the recording engine (Win32 service) that runs as part of a Storage Server. Messages Camera : / frames discarded due to busy drive thread in last 1 minutes. Camera : / frames discarded due to busy frame queue in last 1 minutes. Error resolving name for POP server host: port Error: : Error connecting socket for POP server host: port Error: : POP connection error: 0 POP response: POP user error: 0 POP response: POP password error: 0 POP response: Cause x frames out of y frames are discarded because there were a large number of frames that have been requested to be written in the disk. It is difficult for the current settings of the recording engine to process this amount of tasks. This message is recorded when recording failure occurs when disk is under a heavy load. x frames out of y frames are discarded because there were a large number of unprocessed frames. It may be that CPU or hard disk drive is unable to process data at the same speed rate as the data reception. This message is recorded when recording failure occurs due to motion detection or too many event occurrences. When sending E-mail, the recording engine could not resolve the host name of the POP server. When sending E-mail, the recording engine could not connect to the POP server. When sending E-mail, an error occurred in the first response sent after connecting to the POP server. When sending E-mail, the user name entered for the POP server could not be authenticated. When sending E-mail, the password entered for the POP server could not be verified. Action Reduce the system load using the following methods. 1. Reduce the amount of data to record (For example, lower the resolution or frame rate). 2. Install an additional hard disk. 3. Implement an action such as upgrading the CPU, or increasing memory or existing hard disk space. Reduce the system load using the following methods. 1. Reduce the amount of data to record (For example, lower the resolution or frame rate). 2. Install an additional hard disk. 3. Implement an action such as upgrading the CPU, or increasing memory or existing hard disk space. See the corresponding Winsock error code in "Error Codes in Log File" ( P. 931). See the corresponding Winsock error code in "Error Codes in Log File" ( P. 931). See "Error Codes in Log File" ( P. 9-31). Check the Storage Server configuration to see if the entered user name is correct. Check the Storage Server configuration to see if the entered password is correct. 9-26