Canon C50FSi Network Video Recorder VK-64/VK-16 Administrator's Manual - Page 99
Connect to Camera, If you have a Multi-Terminal Module VB-EX50 unit plugged into a VB-C50i/VB-C50iR
UPC - 013803055962
View all Canon C50FSi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Register Camera Server and Set Recording Schedule Register Camera Server Connect to Camera 1. Enter the Host Name or IP address in [Host Name or IP], then enter the port number for the Camera Server in [Port]. The [Host Name or IP] should be 255 characters or less (each label, separated by a period, must be 63 characters or less), the IP address must be 15 characters or less (each label, separated by a period, must be 3 characters or less), and the [Port] must be a figure within the range from 1 to 65535. 2. Enter the user name and password to connect to the Camera Server. Enter the user name in [User Name] and password in [Password]. The settings are then saved to the Storage Server. Note z Use the user name and password configured on the Camera Server. If the user name and password are not sure, ask for the System Administrator of the Camera Server. z Storage servers and VK Viewers do not support IPv6. 3. Click [Connect]. Once the Viewer has connected with the Camera Server, a tab is shown next to the [Add Camera Server] dialog. Note z You must click [Connect] before clicking [OK] to close the dialog (the [OK] button is disabled until you do so). z When two or more cameras are used with VB150 (when [Video Input] is set to [Multiple]), two through four tabs are added. The number of tabs shown for a VB150 does not indicate the physical number of cameras connected, but indicates the number of cameras which have been enabled using the VB150 [Camera and Video Settings] Page. Please see Chapter 3, P. 36 of the VB150 User's Manual for more details. z If [Video Input] is set to [Single] for VB150, the camera name displayed as the Camera Server Name is the first camera name in the server's camera name list when [Use Camera] is selected on the [Camera and Video Settings] Page. Therefore, it is recommended that the Administrator should set the first camera name to be a general name, applicable to the entire Camera Server. z If you are using a VB150 with the [Settings Web page URL] other than the default setting "admin", a connection error occurs when you click [Connect]. Restore the default setting and try again. Tip If you have a Multi-Terminal Module VB-EX50 unit plugged into a VB-C50i/VB-C50iR, VB-C50FSi, VB-C50Fi and have configured the [Use External Video Input], video seen in the Viewer may be taken from cameras connected to the Multi-Terminal Module. Switch the video at the Admin Viewer as required. 4-19