Canon LV-7545 Owners Manual - Page 12

CONNECTING PROJECTOR CONNECTING TO COMPUTER Cables used for connection (✽ = Cable or adapter is not supplied with this projector.) • VGA Cable (HDB 15 pin) • USB Cable ✽ • DVI-Digital Cable (for Single Link T.M.D.S.) ✽ • MAC Adapter (When connecting to Macintosh computer) • BNC Cable ✽ • Audio Cables (RCA x 2 and Mini Plug (stereo) x 1) ✽ • Control Cable for PS/2 Port, Serial Port or ADB Port IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA) Monitor Output Desktop type Laptop type Monitor Output USB port Audio Output Serial port PS/2 port ADB port BNC Cable ✽ MAC Adapter Set slide switches according to chart below. VGA Cable DVI Cable ✽ USB Cable ✽ Audio Cable ✽ (stereo) Control Cable for Serial Port Terminal Control Cable for PS/2 Port Terminal Control Cable for ADB Port Terminal USB COMPUTER IN ANALOG COMPUTER IN DIGITAL COMPUTER AUDIO IN 1 or 2 INPUT 1 RGB ANALOG RGB DIGITAL R/C JACK AUDIO 1 RESET CONTROL PORT AUDIO 2 G B R H/V V VIDEO/Y Cb/Pb Cr/Pr INPUT 2 VIDEO/Y Cb/Pb Cr/Pr R-AUDIO-L S-VIDEO (MONO) INPUT 3 Terminals of the Projector Use one of these Control Cables corresponding with the terminal of your computer. CONTROL PORT 12 x MAC ADAPTER Set switches as shown in the table below depending on RESOLU- ON TION MODE that you want to use before you turn on projector and computer. OFF ON DIP 123456 1 2 3 4 56 13" MODE (640 x 480) ON ON OFF OFF OFF OFF 16" MODE (832 x 624) OFF ON OFF ON OFF OFF 19" MODE (1024 x 768) OFF ON ON OFF OFF OFF 21" MODE (1152 x 870) ON ON ON ON OFF OFF NOTE : When connecting the cable, the power cords of both the projector and the external equipment should be disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched on.