Canon LV-X300 User Manual - Page 66
Troubleshooting
![]() |
View all Canon LV-X300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Troubleshooting The projector does not turn on Cause Remedy There is no power from the power cable. Attempting to turn the projector on again during the cooling process. Plug the power cord into the AC inlet on the projector, and plug the power cord into the power outlet. If the power outlet has a switch, make sure that it is switched on. Wait until the cooling down process has completed. No picture Cause The video source is not turned on or connected correctly. The projector is not correctly connected to the input signal device. The input signal has not been correctly selected. The lens cover is still closed. Remedy Turn the video source on and check that the signal cable is connected correctly. Check the connection. Select the correct input signal with the SOURCE key on the projector or remote control. Open the lens cover. Blurred image Cause Remedy The projection lens is not correctly focused. The projector and the screen are not aligned properly. The lens cover is still closed. Depending on video signal timing, the projector needs to fine-tune for less blurred image. Adjust the focus of the lens using the focus ring. Adjust the projection angle and direction as well as the height of the unit if necessary. Open the lens cover. Adjust Phase in the IMAGE menu. Remote control does not work Cause The battery is out of power. There is an obstacle between the remote control and the projector. You are too far away from the projector. Remedy Replace the battery with a new one. Remove the obstacle. Stand within 8 meters (26 feet) of the projector. The password is incorrect Cause You do not remember the password. Remedy Please see "Resetting the password function" on page 30 for details. The LAN function cannot be used Cause LAN control settings or LAN cable connection are problematic. The web page is not shown in the web browser or the web page is not responding. Remedy Verify the LAN control settings. Please see "Configuring the LAN Settings" on page 46 for details. Make sure the LAN cables are properly connected. Reload the page to see the data after changing on the screen. If the page is not showing the modified data, check the IP address of projector and log-in again. 66
![](/manual_guide/products/canon-lvs300-user-manual-12432dc/66.png)