Canon LV-X300 User Manual - Page 73
Control Commands, CONTROL port, LAN port
![]() |
View all Canon LV-X300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
ENGLISH Control Commands You can control this projector by sending commands via CONTROL port or LAN port. System Requirement CONTROL port Connection Cable Communication Mode Baud Rate Character Length Parity Check Stop Bits Flow Control 9-pin RS-232-C Cable (Crossover) RS-232-C asynchronous, half-duplex communication 19200 bps 8 bit None 2 bit None LAN port Connection System Port TCP/IP Connection 33336 Control Command Function Read/ Write Operation Command (ASCII) Note W W Power R Power On Power Off Power Status POWER=ON POWER=OFF GET=POWER W W Source W Selection W W R W W Audio R Control W W R Computer1 Computer2 HDMI Video S-Video Current source Mute On Mute Off Mute Status Volume + Volume Volume Status INPUT=DSUB1 INPUT=DSUB2 INPUT=HDMI INPUT=VIDEO INPUT=S-VIDEO GET=INPUT MUTE=ON MUTE=OFF GET=MUTE RC=VOL_P RC=VOL_M GET=AVOL Enable during "Standby" state. Enable during any power state. [Warming up] g:POWER=OFF2ON [Cooling down] g:POWER=ON2OFF 73
![](/manual_guide/products/canon-lvs300-user-manual-12432dc/73.png)