Canon Microfilm Scanner 800II MS-800II Instruction Manual - Page 22
Connecting Via SCSI
![]() |
View all Canon Microfilm Scanner 800II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Before You Begin... $&*& Page 20 Connecting Via SCSI When connecting the scanner to a computer using a SCSI card, use the following SCSI cards and cables. ● SCSI card Use one of the following recommended SCSI cards: Adaptec SCSI card (for PCI bus) • AHA-2930U • AHA-2940AU • ASC-19160 • ASC-29160 When installing a SCSI card on your computer, follow the directions in both the manual for the SCSI card and the computer. ● SCSI cable • The SCSI connector on the scanner is a half-pitch 50pin connector (pin-type). No SCSI cable is supplied with the scanner. To connect the scanner to a computer, obtain a SCSI cable with the correct connectors for the scanner and the SCSI card installed in the computer. • The maximum length of SCSI cables are defined by the SCSI standard. For details, see the user manual for your SCSI card. IMPORTANT • Only one SCSI port can be used on the scanner and terminator setting is fixed to ON. You cannot daisy chain multiple MS800II scanners. • The SCSI ID for the scanner can be set from ID0 to ID5. By default, the SCSI ID for the scanner is set to SCSI ID=2. When changing the SCSI ID setting, make sure to contact an authorized Canon dealer or service professional. • When daisy chaining the scanner with the other SCSI devices, note the following: • Change the ID of the other SCSI devices so they do not to overlap. • Make sure that the scanner is at the end of the chain and the terminate setting of the other devices is OFF. - 20 - 07.5.14, 11:06 "EPCF1BHF.BLFS+11$
![](/manual_guide/products/canon-microfilm-scanner-800ii-ms800ii-instruction-manual-6b86b97/22.png)