Canon Microfilm Scanner 800II MS-800II Instruction Manual - Page 23

$&*& Page 21 Before You Begin... Connecting Via USB USB connectivity is achieved through the use of a SCSIUSB converter connected to the scanner's SCSI port. Connecting via USB means that scanning speeds are slightly slower than when using the SCSI port. ● USB port • Use the Hi-Speed USB 2.0 port that is equipped nor- mally to the computer. • Install the latest Microsoft USB 2.0 drivers. For details, contact an authorized Canon dealer. • Complete functionality using the USB interface is not guaranteed. For details, contact an authorized Canon dealer. ● USB cable Use the supplied USB cable or a Hi-Speed USB 2.0 cable. Connecting to a Computer Setup, configuration, and connection of the scanner to the computer should be done by the supervising service personnel. To change the connection or settings, contact an authorized Canon dealer or service professional. IMPORTANT • The interface cable for connecting to the computer should match the interface used during setup. • After connecting interface the cable to the scanner, attach the ferrite core supplied with the scanner to the cable near the scanner. Do not remove the ferrite core, since this is attached to suppress a cable-noise. • You cannot use a SCSI and a USB connection at the same time. Before changing the interface, make sure to contact an authorized Canon dealer or service professional. Other ● Software • The ISIS-compatible application software or TWAIN- compatible application software that operate normally on the operation system described above. • The ISIS/TWAIN driver provided with the scanner is not necessarily compatible with all ISIS-compatible or TWAIN-compatible application software. For details, contact your application software dealer. - 21 - 07.5.14, 11:06 "EPCF
1BHF.BLFS
+11$