Canon RP10 for CR-120/150 imageFORMULA CR-150 / CR-120 User Manual - Page 68
Check Path Cleaning, Press the Separation OFF Mode Button.
View all Canon RP10 for CR-120/150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Check Path Cleaning Follow the procedures below to perform check path cleaning. A Confirm that the scanner is set to the cleaning mode. (See "Prepare for the Cleaning mode," on p. 67) B Press the Separation OFF Mode Button. Separation OFF Mode Button C Place the cleaning card (for Check Path Cleaning) in the document tray. NOTE Allow 1 to 2 minutes for the moisture on the Canon CR-Series scanner from the cleaning card to thoroughly dry before scanning documents. Card Path Cleaning Follow the procedures below to perform card path cleaning. NOTE When insert the cleaning card (for Card Path Cleaning), use of card guard is recommended. See "About the Card Guard," on p. 48 A Confirm that the scanner is set to the cleaning mode. (See "Prepare for the Cleaning mode," on p. 67) B Press and hold the FUNCTION Button. Press and hold the Function button for at least 2 seconds, and then release it. D Press the Start Button to start cleaning. E Please repeat steps 3 and 4. A typical cleaning is feeding the cleaning card 3 to 7 times. If the scanner is extremely dirty, you may need to use another cleaning card. F Turn OFF the scanner. 68 If the scanner is set to the Card Path Cleaning mode properly, the POWER LED and the Start LED continues to blink.